Please login or register.

Login with username, password and session length


Registration is only required if you want to post, and is not needed to read any posts. To avoid excess 'spam' accounts, all accounts where no posts have been made will be deleted after two weeks. Please register again if you wish to post.

Author Topic: Re: OpenCPN plugin for Bridge Command use  (Read 832 times)

February 25, 2021, 02:36:46 AM
  • Member
  • **
  • Posts: 1
    • View Profile
how can I connect or Integrate the opencpn with the bridge command?
please help me.

February 26, 2021, 10:33:13 PM
Reply #1
  • Administrator
  • Member
  • *****
  • Posts: 116
    • View Profile
Hi, can I check what you have been able to do so far, and any problems you have run into?

Do you want to run Bridge Command and OpenCPN on the same computer, or on different ones?

By default, Bridge Command will send NMEA data over UDP on port 10110 to localhost (i.e. the computer Bridge Command is running on). You can change these settings in the NMEA tab of the Bridge Command 'Settings: Main' section.

In OpenCPN, you can set up the incoming connections as shown in

If you can let me know any specific questions or problems, I may be able to help more.