News:

Registration is only required if you want to post, and is not needed to read any posts. To avoid excess 'spam' accounts, all accounts where no posts have been made will be deleted after two weeks. Please register again if you wish to post.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - E11449

Pages1
#1
Bridge Command General Support / NMEA output via serial port - No activity on port
November 10, 2021, 08:43:59 PM
Hi,
I am trying to get any signal out via the serial port.
I tried different serial adapters including the corresponding COM port numbers in the "Settings:Main"-menu.
But so far nothing works and even the serial adapters show no sign of activity.
(When I was using a NMEA-generator tool, everything works)

Is there any other configuration option I am missing?
Is it possible to change the baud rate of the serial output?


Best regards,
Elmo
Pages1