Bridge Command Forum

Support => Bridge Command General Support => Topic started by: E11449 on November 10, 2021, 08:43:59 PM

Title: NMEA output via serial port - No activity on port
Post by: E11449 on November 10, 2021, 08:43:59 PM
Hi,
I am trying to get any signal out via the serial port.
I tried different serial adapters including the corresponding COM port numbers in the "Settings:Main"-menu.
But so far nothing works and even the serial adapters show no sign of activity.
(When I was using a NMEA-generator tool, everything works)

Is there any other configuration option I am missing?
Is it possible to change the baud rate of the serial output?


Best regards,
Elmo
Title: Re: NMEA output via serial port - No activity on port
Post by: forum_admin on December 18, 2021, 11:49:45 PM
Hi, sorry for the slow reply!

Is this on Windows? For the serial port setting, I think you need 'COM1' or equivalent in the settings, rather than '1'.
If on Linux, you'd need to to be set to something like '/dev/ttyS0'